74ABT574CMSAX

74ABT574CMSAX Overview

The flip flop is packaged in a case of 20-SSOP (0.209, 5.30mm Width). D flip flop is included in the Tape & Reel (TR)package. Currently, the output is configured to use Tri-State, Inverted. It is configured with the trigger Positive Edge. Surface Mountis positioned in the way of this electronic part. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is at -40°C~85°C TAdegrees Celsius that the system is operating. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74ABT series. This D flip flop should not have a frequency greater than 200MHz. The list contains 1 elements. It consumes 50μA of quiescent You can search similar parts based on 74ABT574. A 5pFfarad input capacitance is provided by this T flip flop. It is mounted in the way of Surface Mount. 20pins are included in its design. Its clock edge trigger type is Positive Edge. It is designed with a number of bits of 8. 8 circuits are used to achieve its superior flexibility. For high efficiency, the supply voltage should be kept at 5V. There are no output lines on the JK flip flop. The number of input lines is 1. There is -32mA output current at the high level. The low level output current is set to 64mA. Ideally, the operating temperature should be lower than 85°C. The operating temperature should be higher than -40°C. The minimum voltage required for operation is 4.5V. It supports a maximum supply voltage of 5.5V volts. 200MHzis the maximum frequency that can be achieved.

74ABT574CMSAX Features

Tape & Reel (TR) package
74ABT series
20 pins
8 Bits

74ABT574CMSAX Applications

There are a lot of ON Semiconductor 74ABT574CMSAX Flip Flops applications.

• Safety Clamp
• Frequency Divider circuits
• Convert a momentary switch to a toggle switch
• ESCC
• Counters
• Patented noise
• Shift Registers
• Functionally equivalent to the MC10/100EL29
• Shift registers
• Memory