74ACT11074NSR

74ACT11074NSR Overview

The package is in the form of 14-SOIC (0.209, 5.30mm Width). D flip flop is included in the Cut Tape (CT)package. The output it is configured with uses Differential. The trigger it is configured with uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. In the operating environment, the temperature is -40°C~85°C TA. This D latch has the type D-Type. The 74ACTseries comprises this type of FPGA. Its output frequency should not exceed 125MHz Hz. A total of 14terminations have been recorded. JK flip flop belongs to 74ACT11074 family. A voltage of 5V provides power to the D latch. A JK flip flop with a 3.5pFfarad input capacitance is used here. It belongs to the family of electronic devices known as ACT. A part of the electronic system is mounted in the way of Surface Mount. The 14pins are designed into the board. This device has the clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. To achieve this superior flexibility, 2 circuits are used. In view of its reliability, this D flip flop is a good fit for TR. There are 5V power supplies attached to it. For high efficiency, the supply voltage should be set to 5V. The output current of 24mA makes it feature maximum design flexibility. There are 1 output lines in this JK flip flop. There is a consumption of 4μAof quiescent current from it.

74ACT11074NSR Features

Cut Tape (CT) package
74ACT series
14 pins
5V power supplies

74ACT11074NSR Applications

There are a lot of Texas Instruments 74ACT11074NSR Flip Flops applications.

• Registers
• Set-reset capability
• Memory
• Counters
• Balanced Propagation Delays
• Storage Registers
• Communications
• Pattern generators
• Count Modes
• Individual Asynchronous Resets