CD74AC574M

CD74AC574M Overview

20-SOIC (0.295, 7.50mm Width)is the way it is packaged. The package Tubecontains it. There is a Tri-State, Non-Invertedoutput configured with it. This trigger is configured to use Positive Edge. It is mounted in the way of Surface Mount. With a supply voltage of 1.5V~5.5V volts, it operates. In this case, the operating temperature is -55°C~125°C TA. Logic flip flops of this type are classified as D-Type. This type of FPGA is a part of the 74AC series. It should not exceed 125MHzin its output frequency. In total, it contains 1 elements. It consumes 8μA of quiescent 20terminations have occurred. A voltage of 5V is used to power it. The input capacitance of this T flip flop is 10pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. It belongs to the family of electronic devices known as AC. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. As an additional reference, you may refer to electronic flip flop BROADSIDE VERSION OF 374.

CD74AC574M Features

Tube package
74AC series

CD74AC574M Applications

There are a lot of Rochester Electronics, LLC CD74AC574M Flip Flops applications.

• Load Control
• Memory
• Event Detectors
• Bounce elimination switch
• Differential Individual
• Computers
• Asynchronous counter
• CMOS Process
• Latch-up performance
• Buffer registers