CD74ACT174M96

CD74ACT174M96 Overview

16-SOIC (0.154, 3.90mm Width)is the packaging method. Package Cut Tape (CT)embeds it. As configured, the output uses Non-Inverted. There is a trigger configured with Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at -55°C~125°C TA. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74ACT series. This D flip flop should not have a frequency greater than 80MHz. In total, it contains 1 elements. A total of 16terminations have been recorded. The 74ACT174family includes it. It is powered by a voltage of 5V . The input capacitance of this JK flip flopis 10pF farads. In terms of electronic devices, this device belongs to the ACTfamily of devices. There is an electronic part mounted in the way of Surface Mount. This board is designed with 16pins on it. Its clock edge trigger type is Positive Edge. The part is included in FF/Latches. An electronic part with 6bits has been designed. The superior flexibility is achieved through the use of 7 circuits. Considering its reliability, this T flip flop is well suited for TR. An electrical current of 5V volts is applied to it. For high efficiency, the supply voltage should be set to 5V. Its output current of 24mAallows for maximum design flexibility. It has 6 output lines to operate. In terms of quiescent current, it consumes 8μA .

CD74ACT174M96 Features

Cut Tape (CT) package
74ACT series
16 pins
6 Bits
5V power supplies

CD74ACT174M96 Applications

There are a lot of Texas Instruments CD74ACT174M96 Flip Flops applications.

• Storage Registers
• Registers
• Cold spare funcion
• QML qualified product
• Circuit Design
• Individual Asynchronous Resets
• Balanced 24 mA output drivers
• Synchronous counter
• Load Control
• Dynamic threshold performance