CD74ACT574ME4

CD74ACT574ME4 Overview

SOICis the way it is packaged. There is an embedded version in the package Rail/Tube. D latch consists of 1 elements. 20terminations have occurred. A voltage of 5V is used to power it. This D flip flop belongs to the family of ACT. The electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device exhibits a clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. In order for the device to operate, it requires 5V power supplies. This flip flop has a total of 2ports. The supply voltage should be maintained at 5V for high efficiency. In order for the chip to function, it has 3output lines. As a result, it consumes 8μA of quiescent current without being affected by external factors. A high level output current of -24mAis set. In the low level output current setting, 24mAis used. Ideally, the operating temperature should be lower than 125°C. In order for the system to operate properly, the temperature should be higher than -55°C. The minimum voltage required for operation is 4.5V. In this case, it supports a maximum supply voltage of 5.5V. It is possible to obtain a frequency of 110MHz. There is a logic IC BUS DRIVER used in the D flip flop. There are 1 functions available on this T flip flop. The D latch is equipped with 20 pins. As a result of the output current of 24mA, the design flexibility is maximized.

CD74ACT574ME4 Features

Rail/Tube package
20 pins
5V power supplies
1 Functions
20 pin count

CD74ACT574ME4 Applications

There are a lot of Texas Instruments CD74ACT574ME4 Flip Flops applications.

• Safety Clamp
• Reduced system switching noise
• Divide a clock signal by 2 or 4
• Frequency Divider circuits
• EMI reduction circuitry
• Convert a momentary switch to a toggle switch
• Shift registers
• Supports Live Insertion
• Event Detectors
• Patented noise