CD74HC173PW

CD74HC173PW Overview

The package is in the form of 16-TSSOP (0.173, 4.40mm Width). It is included in the package Tube. This output is configured with Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 2V~6V volts, it operates. It is operating at -55°C~125°C TA. This electronic flip flop is of type D-Type. This type of FPGA is a part of the 74HC series. Its output frequency should not exceed 60MHz Hz. In total, it contains 1 elements. There are 16 terminations,Members of the 74HC173family make up this object. A voltage of 4.5V provides power to the D latch. This JK flip flop has a 10pFfarad input capacitance. This D flip flop belongs to the family of HC/UH. There is an electronic part that is mounted in the way of Surface Mount. The 16pins are designed into the board. In this device, the clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. The flip flop is designed with 4bits. Vsup reaches 6V, the maximal supply voltage. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V. The superior flexibility of this circuit is achieved by using 4 circuits. The 7.8mA output current allows it to be designed with the greatest amount of flexibility. It operates with 3 output lines. A total of 2input lines have been provided. As a result, it consumes 8μA of quiescent current without being affected by external factors. WITH DUAL OUTPUT ENABLEis also one of its characteristics.

CD74HC173PW Features

Tube package
74HC series
16 pins
4 Bits

CD74HC173PW Applications

There are a lot of Texas Instruments CD74HC173PW Flip Flops applications.

• CMOS Process
• Safety Clamp
• Dynamic threshold performance
• Frequency Dividers
• Differential Individual
• Count Modes
• Synchronous counter
• Patented noise
• Frequency division
• Latch