CD74HC377M

CD74HC377M Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. As part of the package Tube, it is embedded. In the configuration, Non-Invertedis used as the output. The trigger configured with it uses Positive Edge. The electronic part is mounted in the way of Surface Mount. Powered by a 2V~6Vvolt supply, it operates as follows. A temperature of -55°C~125°C TAis considered to be the operating temperature. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74HCseries FPGA. Its output frequency should not exceed 60MHz. A total of 1elements are present in it. There have been 20 terminations. The 74HC377 family contains it. A voltage of 5V is used as the power supply for this D latch. This JK flip flop has a 10pFfarad input capacitance. It belongs to the family of electronic devices known as HC/UH. There is an electronic part mounted in the way of Surface Mount. 20pins are included in its design. This device has the clock edge trigger type of Positive Edge. The part you are looking for is included in FF/Latch. This flip flop is designed with 8 Bits. There is a 6Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 2V. The system runs on a power supply of 2/6V watts. In addition to its maximum design flexibility, the output current of the T flip flop is 5.2mA. There are 8 output lines in this JK flip flop. There is 8μA quiescent current consumption by it. As an additional reference, you may refer to electronic flip flop WITH HOLD MODE. A total of 8 channels are available.

CD74HC377M Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

CD74HC377M Applications

There are a lot of Texas Instruments CD74HC377M Flip Flops applications.

• Differential Individual
• Safety Clamp
• Registers
• Frequency Divider circuits
• Data storage
• Parallel data storage
• Pattern generators
• Guaranteed simultaneous switching noise level
• Digital electronics systems
• Shift Registers