CD74HCT564E

CD74HCT564E Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. You can find it in the Tubepackage. T flip flop is configured with an output of Tri-State, Inverted. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis required for its operation. It is operating at a temperature of -55°C~125°C TA. It belongs to the type D-Typeof flip flops. The FPGA belongs to the 74HCT series. You should not exceed 50MHzin the output frequency of the device. A total of 1elements are present in it. It has been determined that there have been 20 terminations. The 74HCT564 family contains it. The power source is powered by 5V. A JK flip flop with a 10pFfarad input capacitance is used here. It is a member of the HCTfamily of D flip flop. The electronic part is mounted in the way of Through Hole. Basically, it is designed with a set of 20 pins. This device's clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. Despite its superior flexibility, it relies on 8 circuits to achieve it. The D latch operates on 5V volts. The flip flop has 2embedded ports. In order to ensure high efficiency, the supply voltage should remain at 5V. With an output current of 6mA, this device offers maximum design flexibility. It is designed with 3 output lines. It consumes 8μA current.

CD74HCT564E Features

Tube package
74HCT series
20 pins
8 Bits
5V power supplies

CD74HCT564E Applications

There are a lot of Texas Instruments CD74HCT564E Flip Flops applications.

• High Performance Logic for test systems
• CMOS Process
• Latch
• Consumer
• Individual Asynchronous Resets
• Divide a clock signal by 2 or 4
• Matched Rise and Fall
• Test & Measurement
• ESD protection
• Buffer registers