DM74ALS174MX

DM74ALS174MX Overview

It is embeded in 16-SOIC (0.154, 3.90mm Width) case. It is included in the package Tape & Reel (TR). It is configured with Non-Invertedas an output. In the configuration of the trigger, Positive Edgeis used. There is an electrical part that is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. In FPGA terms, D flip flop is a type of 74ALSseries FPGA. In order for it to function properly, its output frequency should not exceed 50MHz. A total of 1elements are present in it. It consumes 19mA of quiescent In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is powered from a supply voltage of 5V. In terms of electronic devices, this device belongs to the ALSfamily of devices. As soon as 5.5Vis reached, Vsup reaches its maximum value. Normally, the supply voltage (Vsup) should be above 4.5V.

DM74ALS174MX Features

Tape & Reel (TR) package
74ALS series

DM74ALS174MX Applications

There are a lot of Rochester Electronics, LLC DM74ALS174MX Flip Flops applications.

• ESD protection
• Set-reset capability
• Bounce elimination switch
• Single Down Count-Control Line
• Consumer
• Data storage
• Frequency division
• Frequency Dividers
• Shift registers
• Registers