MC74ACT377DWG

MC74ACT377DWG Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). There is an embedded version in the package Tube. As configured, the output uses Non-Inverted. JK flip flop uses Positive Edgeas the trigger. It is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at a temperature of -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74ACTseries FPGA. A frequency of 140MHzshould be the maximum output frequency. A total of 1 elements are present. This process consumes 8μA quiescents. Terminations are 20. The 74ACT377 family contains this object. It is powered by a voltage of 5V . A 4.5pFfarad input capacitance is provided by this T flip flop. In this case, the D flip flop belongs to the ACTfamily. Electronic part Surface Mountis mounted in the way. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. The part is included in FF/Latches. It is designed with a number of bits of 8. Its superior flexibility is attributed to its use of 8 circuits. It operates from 5V power supplies. A high level of efficiency can be achieved by maintaining the supply voltage at 5V.

MC74ACT377DWG Features

Tube package
74ACT series
20 pins
8 Bits
5V power supplies

MC74ACT377DWG Applications

There are a lot of ON Semiconductor MC74ACT377DWG Flip Flops applications.

• Data Synchronizers
• Storage registers
• Shift registers
• Bus hold
• 2 – Bit synchronous counter
• Set-reset capability
• Parallel data storage
• Asynchronous counter
• Digital electronics systems
• Computers