MC74HC574ADWR2

MC74HC574ADWR2 Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). You can find it in the Tape & Reel (TR)package. It is configured with Tri-State, Non-Invertedas an output. This trigger uses the value Positive Edge. Surface Mountis positioned in the way of this electronic part. With a supply voltage of 2V~6V volts, it operates. It is operating at a temperature of -55°C~125°C TA. This D latch has the type D-Type. FPGAs belonging to the 74HCseries contain this type of chip. There should be no greater frequency than 35MHzon its output. The element count is 1 . It consumes 4μA of quiescent current without being affected by external factors. A total of 20 terminations have been made. An input voltage of 3Vpowers the D latch. Its input capacitance is 10pF farads. Devices in the HC/UHfamily are electronic devices. Vsup reaches its maximum value at 6V. For normal operation, the supply voltage (Vsup) should be above 2V. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line.

MC74HC574ADWR2 Features

Tape & Reel (TR) package
74HC series

MC74HC574ADWR2 Applications

There are a lot of Rochester Electronics, LLC MC74HC574ADWR2 Flip Flops applications.

• Shift registers
• Buffered Clock
• Memory
• Reduced system switching noise
• Parallel data storage
• Data transfer
• Frequency Dividers
• Power down protection
• Data Synchronizers
• Latch