MC74LCX574DTR2G

MC74LCX574DTR2G Overview

The item is packaged in 20-TSSOP (0.173, 4.40mm Width)cases. The package Tape & Reel (TR)contains it. Tri-State, Non-Invertedis the output configured for it. This trigger is configured to use Positive Edge. Surface Mountis positioned in the way of this electronic part. The JK flip flop operates at a voltage of 2V~3.6V. A temperature of -40°C~85°C TAis considered to be the operating temperature. It is an electronic flip flop with the type D-Type. In this case, it is a type of FPGA belonging to the 74LCX series. Its output frequency should not exceed 150MHz Hz. There are 1 elements in it. This process consumes 10μA quiescents. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. D latch belongs to the 74LCX574 family. An input voltage of 3.3Vpowers the D latch. A JK flip flop with a 7pFfarad input capacitance is used here. Devices in the LVC/LCX/Zfamily are electronic devices. It is mounted in the way of Surface Mount. This board has 20 pins. In this device, the clock edge trigger type is Positive Edge. The part is included in FF/Latches. The flip flop is designed with 8bits. A normal operating voltage (Vsup) should remain above 2V. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. A total of 2ports are embedded in the D flip flop. In order to achieve high efficiency, the supply voltage should be maintained at 3.3V. There are 3 output lines in this JK flip flop. The number of channels is growing strong/weak: 8.

MC74LCX574DTR2G Features

Tape & Reel (TR) package
74LCX series
20 pins
8 Bits

MC74LCX574DTR2G Applications

There are a lot of ON Semiconductor MC74LCX574DTR2G Flip Flops applications.

• Digital electronics systems
• Computers
• Single Down Count-Control Line
• Power down protection
• Cold spare funcion
• Latch
• Shift registers
• Single Up Count-Control Line
• 2 – Bit synchronous counter
• Pattern generators