SN74AC374DW

SN74AC374DW Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). The Tubepackage contains it. There is a Tri-State, Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of 2V~6V. Temperature is set to -40°C~85°C TA. D-Typedescribes this flip flop. JK flip flop belongs to the 74ACseries of FPGAs. This D flip flop should not have a frequency greater than 155MHz. In total, it contains 1 elements. It consumes 4μA of quiescent It has been determined that there have been 20 terminations. If you search by 74AC374, you will find similar parts. Power is provided by a 3.3V supply. Input capacitance of this device is 4.5pF farads. This D flip flop belongs to the family of AC. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. There is a clock edge trigger type of Positive Edgeon this device. It is part of the FF/Latchesbase part number family. There are 8bits in its design. 6Vis the maximum supply voltage (Vsup). A normal operating voltage (Vsup) should remain above 2V. Despite its superior flexibility, it relies on 8 circuits to achieve it. The D flip flop has no ports embedded. With a current output of 24mA , it offers maximum design flexibility. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.

SN74AC374DW Features

Tube package
74AC series
20 pins
8 Bits

SN74AC374DW Applications

There are a lot of Texas Instruments SN74AC374DW Flip Flops applications.

• Test & Measurement
• Counters
• Latch-up performance
• Modulo – n – counter
• Common Clocks
• Bus hold
• Parallel data storage
• Power down protection
• Data storage
• Matched Rise and Fall