SN74AC574N

SN74AC574N Overview

20-DIP (0.300, 7.62mm)is the way it is packaged. D flip flop is embedded in the Tube package. Tri-State, Non-Invertedis the output configured for it. The trigger configured with it uses Positive Edge. Through Holeis in the way of this electric part. A 2V~6Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. This D latch has the type D-Type. JK flip flop belongs to the 74ACseries of FPGAs. It should not exceed 153MHzin its output frequency. In total, it contains 1 elements. During its operation, it consumes 4μA quiescent energy. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. This D latch belongs to the family of 74AC574. It is powered by a voltage of 3.3V . The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. It belongs to the family of electronic devices known as AC. There is an electronic part mounted in the way of Through Hole. It is designed with 20 pins. The clock edge trigger type for this device is Positive Edge. This device is part of the Bus Driver/Transceiverbase part number family. There are 8bits in its design. Vsup reaches 6V, the maximal supply voltage. The supply voltage (Vsup) should be kept above 2V for normal operation. There are 2 ports embedded in the flip flops. Its output current of 24mAallows for maximum design flexibility. This input has 3lines in it. There are 8 channels available.

SN74AC574N Features

Tube package
74AC series
20 pins
8 Bits

SN74AC574N Applications

There are a lot of Texas Instruments SN74AC574N Flip Flops applications.

• Asynchronous counter
• Memory
• Automotive
• Set-reset capability
• CMOS Process
• Bus hold
• Consumer
• Frequency Divider circuits
• Shift Registers
• Differential Individual