SN74ACT374N

SN74ACT374N Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. It is included in the package Tube. There is a Tri-State, Non-Invertedoutput configured with it. It is configured with the trigger Positive Edge. It is mounted in the way of Through Hole. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. In this case, the operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. This type of FPGA is a part of the 74ACT series. You should not exceed 160MHzin the output frequency of the device. In total, there are 1 elements. As a result, it consumes 4μA of quiescent current without being affected by external factors. Currently, there are 20 terminations. The 74ACT374 family contains it. A voltage of 5V provides power to the D latch. There is 4.5pF input capacitance for this T flip flop. Devices in the ACTfamily are electronic devices. The electronic part is mounted in the way of Through Hole. The 20pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. It is included in FF/Latches. It is designed with 8bits. Despite its superior flexibility, it relies on 8 circuits to achieve it. A power supply of 5Vis required to operate it. This D flip flop is equipped with 0 ports. The supply voltage should be maintained at 5V for high efficiency. With an output current of 24mA, it is possible to design the device in any way you want. 3input lines are available for you to choose from.

SN74ACT374N Features

Tube package
74ACT series
20 pins
8 Bits
5V power supplies

SN74ACT374N Applications

There are a lot of Texas Instruments SN74ACT374N Flip Flops applications.

• Balanced 24 mA output drivers
• Parallel data storage
• Individual Asynchronous Resets
• Patented noise
• QML qualified product
• Single Up Count-Control Line
• Circuit Design
• Count Modes
• Balanced Propagation Delays
• ESCC