SN74AHCT174PWR

SN74AHCT174PWR Overview

The flip flop is packaged in 16-TSSOP (0.173, 4.40mm Width). As part of the package Tape & Reel (TR), it is embedded. This output is configured with Non-Inverted. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. A temperature of -40°C~85°C TAis considered to be the operating temperature. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74AHCT series. In order for it to function properly, its output frequency should not exceed 115MHz. A total of 1elements are present in it. It consumes 4μA of quiescent In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. If you search by 74AHCT174, you will find similar parts. The power supply voltage is 5V. The input capacitance of this T flip flop is 2pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. An electronic device belonging to the family AHCT/VHCT/VTcan be found here. This electronic part is mounted in the way of Surface Mount. It is designed with 16 pins. This device has the clock edge trigger type of Positive Edge. This device has the base part number FF/Latches. The superior flexibility of this product is achieved by using 7 circuits. Considering the reliability of this T flip flop, it is well suited for TR. It runs on 5Vvolts of power. In order to ensure high efficiency, the supply voltage should remain at 5V. It is reported that there are 3 input lines.

SN74AHCT174PWR Features

Tape & Reel (TR) package
74AHCT series
16 pins
5V power supplies

SN74AHCT174PWR Applications

There are a lot of Texas Instruments SN74AHCT174PWR Flip Flops applications.

• Shift registers
• Memory
• Shift Registers
• ESD protection
• Automotive
• Counters
• Latch-up performance
• Buffer registers
• Registers
• Matched Rise and Fall