SN74HC374N

SN74HC374N Overview

The flip flop is packaged in a case of 20-DIP (0.300, 7.62mm). It is contained within the Tubepackage. The output it is configured with uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Through Holeis in the way of this electric part. A voltage of 2V~6Vis required for its operation. Currently, the operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. In this case, it is a type of FPGA belonging to the 74HC series. This D flip flop should not have a frequency greater than 70MHz. D latch consists of 1 elements. A total of 20terminations have been recorded. The 74HC374 family contains this object. Power is supplied from a voltage of 5V volts. This JK flip flop has a 3pFfarad input capacitance. Devices in the HC/UHfamily are electronic devices. It is mounted by the way of Through Hole. There are 20pins on it. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. Flip flops designed with 8bits are used in this part. It reaches the maximum supply voltage (Vsup) at 6V. It is imperative that the supply voltage (Vsup) is maintained above 2Vin order to ensure normal operation. It operates from 2/6V power supplies. The flip flop has 2ports embedded within it. For high efficiency, the supply voltage should be kept at 5V. Featuring the maximum design flexibility, it has an output current of 7.8mA . Currently, there are 3 input lines present. There is a consumption of 8μAof quiescent current from it. A total of 8 channels are available.

SN74HC374N Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC374N Applications

There are a lot of Texas Instruments SN74HC374N Flip Flops applications.

• QML qualified product
• Memory
• Asynchronous counter
• Instrumentation
• Individual Asynchronous Resets
• Power down protection
• Registers
• Data transfer
• Latch
• Differential Individual