SN74LS109AN

SN74LS109AN Overview

16-DIP (0.300, 7.62mm)is the packaging method. You can find it in the Tubepackage. T flip flop uses Differentialas its output configuration. The trigger configured with it uses Positive Edge. In this case, the electronic component is mounted in the way of Through Hole. A voltage of 4.75V~5.25Vis used as the supply voltage. The operating temperature is 0°C~70°C TA. The type of this D latch is JK Type. FPGAs belonging to the 74LSseries contain this type of chip. This D flip flop should not have a frequency greater than 33MHz. A total of 16terminations have been recorded. It is a member of the 74LS109 family. A voltage of 5V is used as the power supply for this D latch. A device of this type belongs to the family of LS. This electronic part is mounted in the way of Through Hole. It is designed with 16 pins. A Positive Edgeclock edge trigger is used in this device. The part you are looking for is included in FF/Latches. Its flexibility is enhanced by 2 circuits. It runs on 5Vvolts of power. For high efficiency, the supply voltage should be kept at 5V. It offers maximum design flexibility with its output current of 8mA. A total of 5input lines have been provided. As an additional reference, you may refer to electronic flip flop INVERTED K INPUT.

SN74LS109AN Features

Tube package
74LS series
16 pins
5V power supplies

SN74LS109AN Applications

There are a lot of Texas Instruments SN74LS109AN Flip Flops applications.

• Data storage
• Buffer registers
• Power down protection
• Cold spare funcion
• CMOS Process
• Consumer
• Latch-up performance
• Frequency division
• Single Down Count-Control Line
• Shift registers