SN74LVC112ADBR

SN74LVC112ADBR Overview

It is embeded in 16-SSOP (0.209, 5.30mm Width) case. You can find it in the Cut Tape (CT)package. As configured, the output uses Differential. The trigger configured with it uses Negative Edge. Surface Mountis positioned in the way of this electronic part. It operates with a supply voltage of 1.65V~3.6V. -40°C~85°C TAis the operating temperature. JK Typedescribes this flip flop. FPGAs belonging to the 74LVCseries contain this type of chip. Its output frequency should not exceed 150MHz. This process consumes 10μA quiescents. In 16terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The 74LVC112 family contains it. An input voltage of 1.8Vpowers the D latch. A 4.5pFfarad input capacitance is provided by this T flip flop. Devices in the LVC/LCX/Zfamily are electronic devices. In this case, the electronic component is mounted in the way of Surface Mount. Basically, it is designed with a set of 16 pins. The clock edge trigger type for this device is Negative Edge. The part you are looking for is included in FF/Latches. For normal operation, the supply voltage (Vsup) should be above 2V. The superior flexibility is achieved through the use of 2 circuits. In view of its reliability, this D flip flop is a good fit for TR. Its output current of 24mAallows for maximum design flexibility. This input has 3lines in it.

SN74LVC112ADBR Features

Cut Tape (CT) package
74LVC series
16 pins

SN74LVC112ADBR Applications

There are a lot of Texas Instruments SN74LVC112ADBR Flip Flops applications.

• Asynchronous counter
• Bounce elimination switch
• Buffered Clock
• ESD protection
• Bus hold
• Power down protection
• Patented noise
• Dynamic threshold performance
• Reduced system switching noise
• 2 – Bit synchronous counter