SN74LVC112APWR

SN74LVC112APWR Overview

The item is packaged in 16-TSSOP (0.173, 4.40mm Width)cases. There is an embedded version in the package Tape & Reel (TR). In the configuration, Differentialis used as the output. It is configured with a trigger that uses Negative Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 1.65V~3.6V is required for operation. It is operating at a temperature of -40°C~85°C TA. This logic flip flop is classified as type JK Type. In FPGA terms, D flip flop is a type of 74LVCseries FPGA. It should not exceed 150MHzin terms of its output frequency. This process consumes 10μA quiescents. There have been 16 terminations. The 74LVC112 family contains it. It is powered from a supply voltage of 1.8V. Its input capacitance is 4.5pFfarads. This D flip flop belongs to the family of LVC/LCX/Z. In this case, the electronic component is mounted in the way of Surface Mount. It is designed with 16 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Negative Edge. This part is included in FF/Latches. For normal operation, the supply voltage (Vsup) should be kept above 2V. Its flexibility is enhanced by 2 circuits. As a result of its reliable performance, this T flip flop is suitable for TR. With a current output of 24mA , it offers maximum design flexibility. Currently, there are 3 lines of input.

SN74LVC112APWR Features

Tape & Reel (TR) package
74LVC series
16 pins

SN74LVC112APWR Applications

There are a lot of Texas Instruments SN74LVC112APWR Flip Flops applications.

• Reduced system switching noise
• Balanced Propagation Delays
• Safety Clamp
• Control circuits
• Frequency Divider circuits
• Instrumentation
• Balanced 24 mA output drivers
• Test & Measurement
• Latch
• Matched Rise and Fall