SN74LVC74AQPWREP

SN74LVC74AQPWREP Overview

The flip flop is packaged in 14-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Tape & Reel (TR) package. T flip flop uses Differentialas its output configuration. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 2V~3.6V is required for operation. In this case, the operating temperature is -40°C~125°C TA. This D latch has the type D-Type. The 74LVCseries comprises this type of FPGA. This D flip flop should not have a frequency greater than 100MHz. There is 10μA quiescent consumption. Currently, there are 14 terminations. Members of the 74LVC74family make up this object. An input voltage of 2.7Vpowers the D latch. There is 5pF input capacitance for this T flip flop. A device of this type belongs to the family of LVC/LCX/Z. Surface Mount mounts this electronic component. This board has 14 pins. This device's clock edge trigger type is Positive Edge. The RS flip flops belongs to FF/Latches base part number. There is a 3.6Vmaximum supply voltage (Vsup). If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V. Its flexibility is enhanced by 2 circuits. Due to its reliability, this T flip flop is well suited for TR. It runs on 3.3Vvolts of power. With a current output of 24mA , it offers maximum design flexibility. It operates with 1 output lines.

SN74LVC74AQPWREP Features

Tape & Reel (TR) package
74LVC series
14 pins
3.3V power supplies

SN74LVC74AQPWREP Applications

There are a lot of Texas Instruments SN74LVC74AQPWREP Flip Flops applications.

• Cold spare funcion
• 2 – Bit synchronous counter
• Count Modes
• Communications
• Registers
• Frequency Dividers
• Control circuits
• Digital electronics systems
• High Performance Logic for test systems
• Single Down Count-Control Line