SN74LVC821APWR

SN74LVC821APWR Overview

The flip flop is packaged in a case of 24-TSSOP (0.173, 4.40mm Width). It is included in the package Cut Tape (CT). T flip flop is configured with an output of Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. It is mounted in the way of Surface Mount. A supply voltage of 1.65V~3.6V is required for operation. It is operating at a temperature of -40°C~85°C TA. It belongs to the type D-Typeof flip flops. JK flip flop is a part of the 74LVCseries of FPGAs. In order for it to function properly, its output frequency should not exceed 150MHz. There are 1 elements in it. A total of 24 terminations have been made. The object belongs to the 74LVC821 family. The power source is powered by 1.8V. A 5pFfarad input capacitance is provided by this T flip flop. It is a member of the LVC/LCX/Zfamily of D flip flop. A part of the electronic system is mounted in the way of Surface Mount. Basically, it is designed with a set of 24 pins. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. Despite its superior flexibility, it relies on 8 circuits to achieve it. A reliable performance of this D flip flop makes it well suited for use in TR. A D flip flop with 2embedded ports is available. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. There are no output lines on the JK flip flop. In terms of quiescent current, it consumes 10μA .

SN74LVC821APWR Features

Cut Tape (CT) package
74LVC series
24 pins

SN74LVC821APWR Applications

There are a lot of Texas Instruments SN74LVC821APWR Flip Flops applications.

• Divide a clock signal by 2 or 4
• EMI reduction circuitry
• Individual Asynchronous Resets
• Circuit Design
• Cold spare funcion
• Shift Registers
• Single Up Count-Control Line
• ESCC
• Patented noise
• Power down protection