SY10EP51VKG

SY10EP51VKG Overview

It is packaged in the way of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). As part of the package Tube, it is embedded. It is configured with Differentialas an output. The trigger configured with it uses Positive, Negative. This electronic part is mounted in the way of Surface Mount. A supply voltage of -3V~-5.5V is required for operation. In this case, the operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. In terms of FPGAs, it belongs to the 10EP series. A frequency of 3GHzshould not be exceeded by its output. There have been 8 terminations. It is a member of the 10EP51 family. A voltage of 3.3V provides power to the D latch. It belongs to the family of electronic devices known as 10E. The electronic part is mounted in the way of Surface Mount. The 8pins are designed into the board. This device has Negative Edgeas its clock edge trigger type. 1bits are used in its design. As soon as Vsup reaches 5.5V, the maximum supply voltage is reached. Normally, the supply voltage (Vsup) should be above 3V. To achieve this superior flexibility, 1 circuits are used. This T flip flop features a maximum design flexibility due to its output current of 50mA. It consumes 40mA of quiescent current without being affected by external factors. Additionally, it is characterized by NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. A -50mAis set for the high level output current. In the low level output current setting, 50mAis used.

SY10EP51VKG Features

Tube package
10EP series
8 pins
1 Bits

SY10EP51VKG Applications

There are a lot of Microchip Technology SY10EP51VKG Flip Flops applications.

• ESD performance
• Event Detectors
• ATE
• Patented noise
• Reduced system switching noise
• 2 – Bit synchronous counter
• Synchronous counter
• Common Clocks
• Frequency Divider circuits
• Communications