54FCT574ATDB

54FCT574ATDB Overview

It is packaged in the way of CDIP. JK flip flop uses POSITIVE EDGEas the trigger. There have been 20 terminations. A voltage of 5V provides power to the D latch. Electronic devices of this type belong to the FCTfamily. In this case, the electronic component is mounted in the way of Through Hole. The 20pins are designed into the board. The part is included in FF/Latches. An electronic part designed with 8bits is used in this application. In this case, the maximum supply voltage (Vsup) reaches 5.5V. An electrical current of 5V volts is applied to it. The flip flop has 2ports embedded within it. Quiescent current is consumed by the D latch in the amount of 10μA. Additionally, you may refer to the D latch's additional BROADSIDE VERSION OF 374. There is -12mA output current at the high level. There should be a temperature below 125°Cduring operation. Operating temperatures should be above -55°C. The minimal supply voltage is 4.5V. It adopts a logic IC of type BUS DRIVER. There are 1 functions available on the JK flip flop. There are 20 pins on the D latch.

54FCT574ATDB Features

20 pins
8 Bits
5V power supplies
1 Functions
20 pin count

54FCT574ATDB Applications

There are a lot of Integrated Device Technology (IDT) 54FCT574ATDB Flip Flops applications.

• Differential Individual
• Circuit Design
• Divide a clock signal by 2 or 4
• Common Clocks
• Guaranteed simultaneous switching noise level
• Shift registers
• Parallel data storage
• Asynchronous counter
• Memory
• ESCC