74ACT534PC

74ACT534PC Overview

It is packaged in the way of 20-DIP (0.300, 7.62mm). D flip flop is included in the Tubepackage. It is configured with Tri-State, Invertedas an output. It is configured with the trigger Positive Edge. There is an electronic component mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis required for its operation. The operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74ACT series. A frequency of 100MHzshould be the maximum output frequency. A total of 1elements are contained within it. T flip flop consumes 40μA quiescent energy. This D latch belongs to the family of 74ACT534. This JK flip flop has a 4.5pFfarad input capacitance. There is an electronic part mounted in the way of Through Hole. A total of 20pins are provided on this board. This device has Positive Edgeas its clock edge trigger type. The flip flop is designed with 8bits. Despite its superior flexibility, it relies on 8 circuits to achieve it. If high efficiency is desired, the supply voltage should be kept at 5V. It has 3 output lines to operate. This input has 8lines in it. There is -24mA output current at the high level. 24mAis set as the low level output current. If the operating temperature is lower than 85°C, it is recommended. Ideally, the operating temperature should be greater than -40°C. It is powered by 4.5V as its minimum supply voltage. There is a maximum voltage support of 5.5V. We are able to achieve a frequency of 100MHz.

74ACT534PC Features

Tube package
74ACT series
20 pins
8 Bits

74ACT534PC Applications

There are a lot of ON Semiconductor 74ACT534PC Flip Flops applications.

• Safety Clamp
• Buffered Clock
• High Performance Logic for test systems
• Convert a momentary switch to a toggle switch
• Buffer registers
• Memory
• Set-reset capability
• Single Up Count-Control Line
• ESCC
• Computers