74ALVCH32374BFG

74ALVCH32374BFG Overview

D latch consists of 4 elements. There are 96 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. A voltage of 3.3V is used to power it. An electronic device belonging to the family ALVC/VCX/Acan be found here. It is mounted in the way of Surface Mount. With its 96pins, it is designed to work with most electronic flip flops. This device's clock edge trigger type is Positive Edge. It is included in FF/Latches. The design is based on 32bits. An electrical current of 3.3V volts is applied to it. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It consumes a total of 40μA quiescent current at any given time. -24mAis set as the high level output current. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be below 85°C. It should be higher than -40°Cwhen the system is operating. In order for it to operate, a supply voltage of 2.3Vis required. The maximum supply voltage supported by the flip flop is 3.6V. This can be achieved at a frequency of 150MHz. There is a logic IC BUS DRIVER used in the D flip flop. There are 4 functions available on the JK flip flop. 96pins are provided on the D latch.

74ALVCH32374BFG Features

96 pins
32 Bits
3.3V power supplies
4 Functions
96 pin count

74ALVCH32374BFG Applications

There are a lot of Integrated Device Technology (IDT) 74ALVCH32374BFG Flip Flops applications.

• Buffer registers
• Data transfer
• EMI reduction circuitry
• Control circuits
• Shift registers
• Computing
• Set-reset capability
• Frequency Divider circuits
• Guaranteed simultaneous switching noise level
• Computers