74FCT162374ATPAG8

74FCT162374ATPAG8 Overview

TSSOPis the packaging method. A total of 2 elements are present. In 48terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The power source is powered by 5V. In terms of electronic devices, this device belongs to the FCTfamily of devices. It is mounted by the way of Surface Mount. With its 48pins, it is designed to work with most electronic flip flops. This device exhibits a clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. The design is based on 16bits. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. A total of 5V power supplies are needed to run it. The flip flop has 2ports embedded within it. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. Despite external influences, it consumes 500μAof quiescent current. -24mAis set as the high level output current. The low level output current is set to 24mA. Ideally, the operating temperature should be below 85°C. Operating temperatures should be above -40°C. It operates with the minimal supply voltage of 4.5V. It supports the maximal supply voltage of 5.5V. The logic IC it uses is BUS DRIVER. It is equipped with 2 functions . The JK flip flop has a pin count of 48.

74FCT162374ATPAG8 Features

48 pins
16 Bits
5V power supplies
2 Functions
48 pin count

74FCT162374ATPAG8 Applications

There are a lot of Integrated Device Technology (IDT) 74FCT162374ATPAG8 Flip Flops applications.

• Bus hold
• Latch-up performance
• Guaranteed simultaneous switching noise level
• Matched Rise and Fall
• EMI reduction circuitry
• 2 – Bit synchronous counter
• Control circuits
• Single Up Count-Control Line
• Pattern generators
• Shift Registers