DM74AS374WM

DM74AS374WM Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). You can find it in the Tubepackage. This output is configured with Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is at 0°C~70°C TAdegrees Celsius that the system is operating. It is an electronic flip flop with the type D-Type. JK flip flop is a part of the 74ASseries of FPGAs. You should not exceed 125MHzin the output frequency of the device. In total, it contains 1 elements. There is 120mA quiescent consumption. You can search similar parts based on 74AS374. There is an electronic component mounted in the way of Surface Mount. There are 20pins on it. A Positive Edgeclock edge trigger is used in this device. There are 8bits in its design. The superior flexibility of this circuit is achieved by using 1 circuits. For high efficiency, the supply voltage should be set to 5V. In order to operate, the chip has 8 output lines. There are 8 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. The high level output current is set to -15mA. In the low level output current setting, the current is set to 48mA. A temperature below 70°Cshould be used for operation. A temperature above 0°Cshould be used for the operation. The minimum voltage required for operation is 4.5V. 5.5Vis the maximum supply voltage it supports. This frequency can be achieved at 125MHz.

DM74AS374WM Features

Tube package
74AS series
20 pins
8 Bits

DM74AS374WM Applications

There are a lot of ON Semiconductor DM74AS374WM Flip Flops applications.

• Balanced Propagation Delays
• Load Control
• Circuit Design
• Single Down Count-Control Line
• Common Clocks
• Buffer registers
• Bounce elimination switch
• Clock pulse
• ESCC
• EMI reduction circuitry