74ABT273CMTC

74ABT273CMTC Overview

The item is packaged in 20-TSSOP (0.173, 4.40mm Width)cases. As part of the package Tube, it is embedded. T flip flop uses Non-Invertedas its output configuration. The trigger configured with it uses Positive Edge. It is mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is at -40°C~85°C TAdegrees Celsius that the system is operating. D-Typedescribes this flip flop. JK flip flop belongs to the 74ABTseries of FPGAs. You should not exceed 200MHzin its output frequency. D latch consists of 1 elements. It consumes 50μA of quiescent D latch belongs to the 74ABT273 family. A 5pFfarad input capacitance is provided by this T flip flop. A part of the electronic system is mounted in the way of Surface Mount. There are 20pins on it. There is a clock edge trigger type of Positive Edgeon this device. The flip flop is designed with 8bits. Using 8 circuits, it is highly flexible. Optimal efficiency requires a supply voltage of 5V. There are 8 output lines in this JK flip flop. It is reported that there are 3 input lines. In this case, the high level output current is set to -32mA. In the low level output current setting, 64mAis used. It is recommended that the operating temperature be lower than 85°C. A temperature above -40°Cshould be used for the operation. The system operates with a minimum supply voltage of 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. This frequency can be achieved at 200MHz.

74ABT273CMTC Features

Tube package
74ABT series
20 pins
8 Bits

74ABT273CMTC Applications

There are a lot of ON Semiconductor 74ABT273CMTC Flip Flops applications.

• Computing
• Dynamic threshold performance
• Safety Clamp
• Functionally equivalent to the MC10/100EL29
• Consumer
• Parallel data storage
• Counters
• EMI reduction circuitry
• ATE
• Test & Measurement