74ABT273CMTCX

74ABT273CMTCX Overview

The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). D flip flop is included in the Tape & Reel (TR)package. This output is configured with Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. The 74ABTseries comprises this type of FPGA. There should be no greater frequency than 200MHzon its output. A total of 1elements are present in it. There is 50μA quiescent consumption. The 74ABT273 family contains it. A JK flip flop with a 5pFfarad input capacitance is used here. The electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device exhibits a clock edge trigger type of Positive Edge. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. Optimal efficiency requires a supply voltage of 5V. The JK flip flop is with 8 output lines to operate. The number of input lines is 3. -32mAis the output current at high level. 64mA is the low level output current. It is recommended that the operating temperature be lower than 85°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. It supports the maximal supply voltage of 5.5V. It is possible to achieve a frequency of 200MHz.

74ABT273CMTCX Features

Tape & Reel (TR) package
74ABT series
20 pins
8 Bits

74ABT273CMTCX Applications

There are a lot of ON Semiconductor 74ABT273CMTCX Flip Flops applications.

• Patented noise
• Divide a clock signal by 2 or 4
• Convert a momentary switch to a toggle switch
• Counters
• Frequency Dividers
• Automotive
• Buffer registers
• Individual Asynchronous Resets
• Data transfer
• Common Clocks