74ABT374CSC

74ABT374CSC Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). As part of the package Tube, it is embedded. Currently, the output is configured to use Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis in the way of this electric part. The JK flip flop operates at a voltage of 4.5V~5.5V. A temperature of -40°C~85°C TAis used in the operation. There is D-Type type of electronic flip flop associated with this device. In this case, it is a type of FPGA belonging to the 74ABT series. It should not exceed 200MHzin terms of its output frequency. The element count is 1 . T flip flop consumes 50μA quiescent energy. The 74ABT374 family contains it. Its input capacitance is 5pF farads. There is an electronic part that is mounted in the way of Surface Mount. There are 20pins on it. It has a clock edge trigger type of Positive Edge. An electronic part designed with 8bits is used in this application. Its superior flexibility is attributed to its use of 8 circuits. Optimal efficiency requires a supply voltage of 5V. In order to operate, the chip has 3 output lines. This input has 1lines in it. In this case, the high level output current is set to -32mA. A 64mAvalue is set for low-level output current. It is recommended that the operating temperature be lower than 85°C. The operating temperature should be higher than -40°C. The system operates with a minimum supply voltage of 4.5V. It supports a maximum supply voltage of 5.5V volts. A frequency of 200MHzcan be achieved.

74ABT374CSC Features

Tube package
74ABT series
20 pins
8 Bits

74ABT374CSC Applications

There are a lot of ON Semiconductor 74ABT374CSC Flip Flops applications.

• Count Modes
• Load Control
• Individual Asynchronous Resets
• Asynchronous counter
• Circuit Design
• Reduced system switching noise
• Synchronous counter
• Frequency Dividers
• Registers
• Common Clocks