74ABT374CSJ

74ABT374CSJ Overview

20-SOIC (0.209, 5.30mm Width)is the packaging method. Package Tubeembeds it. In the configuration, Tri-State, Non-Invertedis used as the output. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at a temperature of -40°C~85°C TA. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74ABT series. You should not exceed 200MHzin its output frequency. In total, it contains 1 elements. It consumes 50μA of quiescent current without being affected by external factors. D latch belongs to the 74ABT374 family. This JK flip flop has a 5pFfarad input capacitance. A part of the electronic system is mounted in the way of Surface Mount. 20pins are included in its design. This device has the clock edge trigger type of Positive Edge. This flip flop is designed with 8 Bits. The superior flexibility of this circuit is achieved by using 8 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. There are 3 output lines in this JK flip flop. Currently, there are 1 lines of input. -32mAis the output current at high level. There is 64mA output current at the low level. Ideally, the operating temperature should be lower than 85°C. In order for the system to operate properly, the temperature should be higher than -40°C. It operates with the minimal supply voltage of 4.5V. It supports the maximal supply voltage of 5.5V. It is possible to obtain a frequency of 200MHz.

74ABT374CSJ Features

Tube package
74ABT series
20 pins
8 Bits

74ABT374CSJ Applications

There are a lot of ON Semiconductor 74ABT374CSJ Flip Flops applications.

• Bounce elimination switch
• Frequency division
• Circuit Design
• Communications
• Convert a momentary switch to a toggle switch
• Computing
• Event Detectors
• Shift registers
• Functionally equivalent to the MC10/100EL29
• Power down protection