74ABT377ADB,118

74ABT377ADB,118 Overview

It is embeded in 20-SSOP (0.209, 5.30mm Width) case. You can find it in the Tape & Reel (TR)package. T flip flop uses Non-Invertedas the output. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ABTseries contain this type of chip. You should not exceed 250MHzin the output frequency of the device. A total of 1elements are present in it. It consumes 250μA of quiescent There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The 74ABT377 family contains it. An input voltage of 5Vpowers the D latch. The input capacitance of this T flip flop is 4pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. The electronic device belongs to the ABTfamily. The part is included in FF/Latches. There is a 5.5Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 4.5V. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. A power supply of 5Vis required to operate it. As an additional reference, you may refer to electronic flip flop WITH HOLD MODE.

74ABT377ADB,118 Features

Tape & Reel (TR) package
74ABT series
5V power supplies

74ABT377ADB,118 Applications

There are a lot of NXP USA Inc. 74ABT377ADB,118 Flip Flops applications.

• Memory
• Computers
• Communications
• Shift Registers
• Power down protection
• Bounce elimination switch
• QML qualified product
• Consumer
• Data storage
• Reduced system switching noise