74AC175PC

74AC175PC Overview

As a result, it is packaged as 16-DIP (0.300, 7.62mm). As part of the package Tube, it is embedded. Differentialis the output configured for it. It is configured with the trigger Positive Edge. It is mounted in the way of Through Hole. The JK flip flop operates at 2V~6Vvolts. A temperature of -40°C~85°C TAis used in the operation. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74ACseries FPGA. This D flip flop should not have a frequency greater than 244MHz. A total of 1elements are contained within it. There is 40μA quiescent consumption. D latch belongs to the 74AC175 family. JK flip flop input capacitance is 4.5pF farads. The electronic part is mounted in the way of Through Hole. The 16pins are designed into the board. There is a clock edge trigger type of Positive Edgeon this device. It is designed with a number of bits of 4. The superior flexibility of this circuit is achieved by using 4 circuits. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. It has 2 output lines to operate. There are 1 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. -24mAis set as the high level output current. 24mA is the low level output current. Operating temperatures should be lower than 85°C. Temperatures above -40°Cshould be used. Initially, it requires a voltage of 2V as the minimum supply voltage. 6Vis its maximum supply voltage. This frequency can be achieved at 244MHz.

74AC175PC Features

Tube package
74AC series
16 pins
4 Bits

74AC175PC Applications

There are a lot of ON Semiconductor 74AC175PC Flip Flops applications.

• Single Up Count-Control Line
• Computers
• Synchronous counter
• Count Modes
• Clock pulse
• ESD protection
• Storage Registers
• Individual Asynchronous Resets
• Event Detectors
• Balanced Propagation Delays