74AC273MTC

74AC273MTC Overview

As a result, it is packaged as 20-TSSOP (0.173, 4.40mm Width). A package named Tubeincludes it. The output it is configured with uses Non-Inverted. The trigger configured with it uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 2V~6V volts, it operates. A temperature of -40°C~85°C TAis considered to be the operating temperature. D-Typedescribes this flip flop. In this case, it is a type of FPGA belonging to the 74AC series. A frequency of 175MHzshould be the maximum output frequency. A total of 1elements are contained within it. During its operation, it consumes 40μA quiescent energy. D latch belongs to the 74AC273 family. There is 4.5pF input capacitance for this T flip flop. This electronic part is mounted in the way of Surface Mount. The 20pins are designed into the board. Its clock edge trigger type is Positive Edge. The design is based on 8bits. The superior flexibility is achieved through the use of 8 circuits. The 24mA output current allows it to be designed with the greatest amount of flexibility. There are 8 output lines on it. Currently, there are 3 lines of input. There is -24mA output current at the high level. It is set to 24mAfor low level output current. Ideally, the operating temperature should be lower than 85°C. If the operating temperature is higher than -40°C, the system should operate properly. It operates with the minimal supply voltage of 2V. 6Vis the maximum supply voltage supported by it. A frequency of 175MHzcan be achieved.

74AC273MTC Features

Tube package
74AC series
20 pins
8 Bits

74AC273MTC Applications

There are a lot of ON Semiconductor 74AC273MTC Flip Flops applications.

• Single Up Count-Control Line
• Balanced Propagation Delays
• Shift registers
• EMI reduction circuitry
• Circuit Design
• Parallel data storage
• Power down protection
• Convert a momentary switch to a toggle switch
• Single Down Count-Control Line
• QML qualified product