74AC273PC

74AC273PC Overview

In the form of 20-DIP (0.300, 7.62mm), it has been packaged. There is an embedded version in the package Tube. In the configuration, Non-Invertedis used as the output. The trigger it is configured with uses Positive Edge. There is an electric part mounted in the way of Through Hole. With a supply voltage of 2V~6V volts, it operates. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. JK flip flop belongs to the 74ACseries of FPGAs. In order for it to function properly, its output frequency should not exceed 175MHz. In total, it contains 1 elements. There is a consumption of 40μAof quiescent energy. This D latch belongs to the family of 74AC273. A JK flip flop with a 4.5pFfarad input capacitance is used here. Electronic part Through Holeis mounted in the way. The electronic flip flop is designed with pins 20. This device's clock edge trigger type is Positive Edge. The flip flop is designed with 8bits. Its superior flexibility is attributed to its use of 8 circuits. Its output current of 24mAallows for maximum design flexibility. There are no output lines on the JK flip flop. 3input lines are available for you to choose from. A -24mAvalue is set for the high level output current. 24mAis set as the low level output current. Temperatures below 85°Care ideal for operating. It is recommended that the operating temperature be greater than -40°C. It is powered by 2V as its minimum supply voltage. 6Vis its maximum supply voltage. 175MHzis the maximum frequency that can be achieved. In its basic building block, there are 8 gates. There are 1 inputs involved.

74AC273PC Features

Tube package
74AC series
20 pins
8 Bits
8 gates

74AC273PC Applications

There are a lot of ON Semiconductor 74AC273PC Flip Flops applications.

• Data storage
• Memory
• Registers
• CMOS Process
• EMI reduction circuitry
• Set-reset capability
• Load Control
• Storage Registers
• Communications
• Patented noise