74AC273SC

74AC273SC Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). You can find it in the Tubepackage. T flip flop uses Non-Invertedas the output. Positive Edgeis the trigger it is configured with. The electronic part is mounted in the way of Surface Mount. The supply voltage is set to 2V~6V. It is operating at -40°C~85°C TA. The type of this D latch is D-Type. JK flip flop belongs to the 74ACseries of FPGAs. It should not exceed 175MHzin its output frequency. In total, there are 1 elements. There is a consumption of 40μAof quiescent energy. If you search by 74AC273, you will find similar parts. This JK flip flop has a 4.5pFfarad input capacitance. There is an electronic part that is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device exhibits a clock edge trigger type of Positive Edge. It is designed with a number of bits of 8. Due to its superior flexibility, it uses 8 circuits. With an output current of 24mA, it is possible to design the device in any way you want. It operates with 8 output lines. This input has 3lines. A -24mAvalue is set for the high level output current. 24mA is the low level output current. A temperature below 85°Cis recommended for operation. It should be higher than -40°Cwhen the system is operating. The minimum voltage required for operation is 2V. It is capable of supporting a maximum supply voltage of 6V. This can be achieved at a frequency of 175MHz.

74AC273SC Features

Tube package
74AC series
20 pins
8 Bits

74AC273SC Applications

There are a lot of ON Semiconductor 74AC273SC Flip Flops applications.

• Parallel data storage
• ESD protection
• Differential Individual
• Data transfer
• Balanced Propagation Delays
• Memory
• Circuit Design
• Patented noise
• Digital electronics systems
• Test & Measurement