74AC374SCX

74AC374SCX Overview

In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. It is contained within the Tape & Reel (TR)package. Currently, the output is configured to use Tri-State, Non-Inverted. This trigger uses the value Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. It is at -40°C~85°C TAdegrees Celsius that the system is operating. D-Typedescribes this flip flop. In terms of FPGAs, it belongs to the 74AC series. You should not exceed 155MHzin the output frequency of the device. In total, it contains 1 elements. As a result, it consumes 40μA quiescent current. The object belongs to the 74AC374 family. This T flip flop has a capacitance of 4.5pF farads at the input. In this case, the electronic component is mounted in the way of Surface Mount. This board has 20 pins. A Positive Edgeclock edge trigger is used in this device. Flip flops designed with 8bits are used in this part. Despite its superior flexibility, it relies on 8 circuits to achieve it. In order for the chip to function, it has 8output lines. 1input lines are available for you to choose from. A -24mAis set for the high level output current. Low level output current is set to 24mA. Ideally, the operating temperature should be below 85°C. The operating temperature should be higher than -40°C. It is powered by 2V as its minimum supply voltage. 6Vis its maximum supply voltage. 100MHzis the maximum frequency that can be achieved.

74AC374SCX Features

Tape & Reel (TR) package
74AC series
20 pins
8 Bits

74AC374SCX Applications

There are a lot of ON Semiconductor 74AC374SCX Flip Flops applications.

• Cold spare funcion
• Patented noise
• ESD protection
• Dynamic threshold performance
• Storage registers
• Parallel data storage
• Latch-up performance
• Buffer registers
• Circuit Design
• CMOS Process