74AC374SJX

74AC374SJX Overview

It is packaged in the way of 20-SOIC (0.209, 5.30mm Width). There is an embedded version in the package Tape & Reel (TR). There is a Tri-State, Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. A voltage of 2V~6Vis used as the supply voltage. It is operating at a temperature of -40°C~85°C TA. This D latch has the type D-Type. In FPGA terms, D flip flop is a type of 74ACseries FPGA. You should not exceed 155MHzin its output frequency. In total, it contains 1 elements. This process consumes 40μA quiescents. You can search similar parts based on 74AC374. The input capacitance of this JK flip flopis 4.5pF farads. Electronic part Surface Mountis mounted in the way. A total of 20pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This flip flop is designed with 8 Bits. To achieve this superior flexibility, 8 circuits are used. It operates with 8 output lines. It has 1lines. It is set to -24mAfor the high level output current. It is set to 24mAfor the low level output current. Ideally, the operating temperature should be lower than 85°C. A temperature above -40°Cshould be used for the operation. The minimal supply voltage is 2V. In this case, it supports a maximum supply voltage of 6V. It is possible to achieve 155MHz frequencies.

74AC374SJX Features

Tape & Reel (TR) package
74AC series
20 pins
8 Bits

74AC374SJX Applications

There are a lot of ON Semiconductor 74AC374SJX Flip Flops applications.

• Count Modes
• Latch
• ESD performance
• 2 – Bit synchronous counter
• Memory
• Clock pulse
• Bus hold
• Convert a momentary switch to a toggle switch
• ATE
• Common Clocks