74AC573MTC

74AC573MTC Overview

In the 20-TSSOP (0.173, 4.40mm Width) package, it can be found as an embedded module. It is packaged in the way of Tube. The output it is configured with uses Tri-State. This electrical device has the logic type D-Type Transparent Latch. A Surface Mount mount is used for mounting this electronic part. It operates with a supply voltage of 2V~6V. A temperature of -40°C~85°C is set as the operating temperature. This FPGA is part of the 74AC series. 8 Bits are used in the design of this electronic part. There is no doubt that it belongs to the family 74AC573. There are 20 pins on it. Surface Mount is used to mount this electronic part. Electronic circuits comprise 2 input lines. Its 24mA output current allows for maximum design flexibility. A binary equivalent of the input line is generated by the 3 output lines. 1 elements are present in it. 8 circuits are used to provide this superior level of flexibility. 24mA is the low level output current. It has been set to -24mA for the high level output current. Ideally, the temperature should not be higher than 85°C. -40°C is the minimum operating temperature. It supports a maximum supply voltage of 6V. In order for the machine to operate, the supply voltage must be 2V.

74AC573MTC Features

20-TSSOP (0.173, 4.40mm Width) package
74AC series
8 Bits
74AC573 family
20 pins
1 elements

74AC573MTC Applications

There are a lot of ON Semiconductor 74AC573MTC Latches applications.

• A/D converters
• Bus system register with enable parallel lines at bus side
• Meter applications
• Shift left register
• Registers
• Parallel data storage
• Counter
• Decade counting 7-segment decimal display
• Multi-line decoders
• Stacked or Push-Down Registers