74AC574MTC

74AC574MTC Overview

20-TSSOP (0.173, 4.40mm Width)is the way it is packaged. As part of the package Tube, it is embedded. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. A temperature of -40°C~85°C TAis considered to be the operating temperature. The type of this D latch is D-Type. The 74ACseries comprises this type of FPGA. A frequency of 153MHzshould not be exceeded by its output. The list contains 1 elements. As a result, it consumes 40μA quiescent current. The 74AC574 family contains this object. JK flip flop input capacitance is 4.5pF farads. The electronic part is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. This device exhibits a clock edge trigger type of Positive Edge. There are 8bits in this flip flop. To achieve this superior flexibility, 8 circuits are used. There are 3 output lines on it. This input has 1lines in it. In this case, the high level output current is set to -24mA. It is set to 24mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. Operating temperatures should be above -40°C. In order for it to operate, a supply voltage of 2Vis required. 6Vis the maximum supply voltage it supports. It is possible to achieve 153MHz frequencies.

74AC574MTC Features

Tube package
74AC series
20 pins
8 Bits

74AC574MTC Applications

There are a lot of ON Semiconductor 74AC574MTC Flip Flops applications.

• Load Control
• Safety Clamp
• Single Down Count-Control Line
• Single Up Count-Control Line
• ATE
• Divide a clock signal by 2 or 4
• Frequency division
• EMI reduction circuitry
• Computers
• Clock pulse