74AC574MTCX

74AC574MTCX Overview

The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). It is included in the package Tape & Reel (TR). It is configured with Tri-State, Non-Invertedas an output. The trigger configured with it uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 2V~6V is required for operation. In the operating environment, the temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. It is a type of FPGA belonging to the 74AC series. It should not exceed 153MHzin its output frequency. D latch consists of 1 elements. As a result, it consumes 40μA quiescent current. You can search similar parts based on 74AC574. Input capacitance of this device is 4.5pF farads. There is an electronic part mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. Its clock edge trigger type is Positive Edge. There are 8bits in its design. To achieve this superior flexibility, 8 circuits are used. There are 3 output lines on it. It is reported that there are 1 input lines. There is -24mA output current at the high level. In the low level output current setting, the current is set to 24mA. A temperature below 85°Cis recommended for operation. Ideally, the operating temperature should be greater than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. It supports a maximum supply voltage of 6V volts. It is possible to obtain a frequency of 153MHz.

74AC574MTCX Features

Tape & Reel (TR) package
74AC series
20 pins
8 Bits

74AC574MTCX Applications

There are a lot of ON Semiconductor 74AC574MTCX Flip Flops applications.

• Data Synchronizers
• Matched Rise and Fall
• Communications
• ESCC
• Single Down Count-Control Line
• Memory
• Safety Clamp
• Set-reset capability
• Digital electronics systems
• Buffered Clock