74AC74SJ

74AC74SJ Overview

It is embeded in 14-SOIC (0.209, 5.30mm Width) case. It is included in the package Tube. There is a Differentialoutput configured with it. The trigger configured with it uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. -40°C~85°C TAis the operating temperature. This logic flip flop is classified as type D-Type. FPGAs belonging to the 74ACseries contain this type of chip. It should not exceed 160MHzin its output frequency. A total of 2 elements are present. This process consumes 20μA quiescents. This D latch belongs to the family of 74AC74. Its input capacitance is 4.5pF farads. A part of the electronic system is mounted in the way of Surface Mount. Basically, it is designed with a set of 14 pins. This device has Positive Edgeas its clock edge trigger type. An electronic part designed with 2bits is used in this application. Its flexibility is enhanced by 2 circuits. It operates with 2 output lines. As of now, there are 4input lines. The high level output current is set to -24mA. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be lower than 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. 6Vis the maximum supply voltage supported by it. We are able to achieve a frequency of 165MHz.

74AC74SJ Features

Tube package
74AC series
14 pins
2 Bits

74AC74SJ Applications

There are a lot of ON Semiconductor 74AC74SJ Flip Flops applications.

• Control circuits
• Modulo – n – counter
• Cold spare funcion
• Registers
• Memory
• Parallel data storage
• Shift Registers
• Divide a clock signal by 2 or 4
• Common Clocks
• Data Synchronizers