74AC74SJX

74AC74SJX Overview

The package is in the form of 14-SOIC (0.209, 5.30mm Width). There is an embedded version in the package Tape & Reel (TR). This output is configured with Differential. It is configured with a trigger that uses Positive Edge. Surface Mountis positioned in the way of this electronic part. With a supply voltage of 2V~6V volts, it operates. It is operating at -40°C~85°C TA. The type of this D latch is D-Type. FPGAs belonging to the 74ACseries contain this type of chip. Its output frequency should not exceed 160MHz. D latch consists of 2 elements. As a result, it consumes 20μA quiescent current. JK flip flop belongs to 74AC74 family. There is 4.5pF input capacitance for this T flip flop. It is mounted in the way of Surface Mount. There are 14pins on it. The clock edge trigger type for this device is Positive Edge. 2bits are used in its design. Despite its superior flexibility, it relies on 2 circuits to achieve it. In order to operate, the chip has 2 output lines. It has 4lines. It is set to -24mAfor the high level output current. There is no low level output current set at 24mA. Ideally, the operating temperature should be lower than 85°C. A temperature above -40°Cshould be used for the operation. The minimum voltage required for operation is 2V. There is a maximum supply voltage of 6V. It is possible to achieve a frequency of 165MHz.

74AC74SJX Features

Tape & Reel (TR) package
74AC series
14 pins
2 Bits

74AC74SJX Applications

There are a lot of ON Semiconductor 74AC74SJX Flip Flops applications.

• Set-reset capability
• Frequency Divider circuits
• Counters
• Bounce elimination switch
• Guaranteed simultaneous switching noise level
• Event Detectors
• Single Up Count-Control Line
• Computers
• Bus hold
• Data Synchronizers