74ACQ374PC

74ACQ374PC Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. D flip flop is embedded in the Tube package. The output it is configured with uses Tri-State, Non-Inverted. This trigger uses the value Positive Edge. It is mounted in the way of Through Hole. A voltage of 2V~6Vis required for its operation. Currently, the operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74ACQseries FPGA. You should not exceed 90MHzin its output frequency. In total, it contains 1 elements. T flip flop consumes 40μA quiescent energy. Members of the 74ACQ374family make up this object. Its input capacitance is 4.5pFfarads. It is mounted in the way of Through Hole. A total of 20pins are provided on this board. Its clock edge trigger type is Positive Edge. Flip flops designed with 8bits are used in this part. The superior flexibility is achieved through the use of 8 circuits. In order for the chip to function, it has 3output lines. 1input lines are available for you to choose from. A high level output current of -24mAis set. In the low level output current setting, 24mAis used. A temperature below 85°Cshould be used for operation. In order for the system to operate properly, the temperature should be higher than -40°C. The minimal supply voltage is 2V. 6Vis the maximum supply voltage supported by it. The frequency can be set to 90MHz.

74ACQ374PC Features

Tube package
74ACQ series
20 pins
8 Bits

74ACQ374PC Applications

There are a lot of ON Semiconductor 74ACQ374PC Flip Flops applications.

• Circuit Design
• Safety Clamp
• Control circuits
• Counters
• ATE
• CMOS Process
• Differential Individual
• Event Detectors
• Convert a momentary switch to a toggle switch
• Single Down Count-Control Line