74ACT11074DR

74ACT11074DR Overview

It is packaged in the way of 14-SOIC (0.154, 3.90mm Width). It is contained within the Tape & Reel (TR)package. The output it is configured with uses Differential. The trigger it is configured with uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is at -40°C~85°C TAdegrees Celsius that the system is operating. The type of this D latch is D-Type. It is a type of FPGA belonging to the 74ACT series. Its output frequency should not exceed 125MHz. 14terminations have occurred. JK flip flop belongs to 74ACT11074 family. A voltage of 5V provides power to the D latch. The input capacitance of this T flip flop is 3.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. The electronic device belongs to the ACTfamily. It is mounted by the way of Surface Mount. The electronic flip flop is designed with pins 14. This device's clock edge trigger type is Positive Edge. It is included in FF/Latches. The superior flexibility is achieved through the use of 2 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. If high efficiency is desired, the supply voltage should be kept at 5V. The 24mA output current allows it to be designed with the greatest amount of flexibility. It operates with 1 output lines. In terms of quiescent current, it consumes 4μA .

74ACT11074DR Features

Tape & Reel (TR) package
74ACT series
14 pins
5V power supplies

74ACT11074DR Applications

There are a lot of Texas Instruments 74ACT11074DR Flip Flops applications.

• Single Up Count-Control Line
• CMOS Process
• Single Down Count-Control Line
• Matched Rise and Fall
• Divide a clock signal by 2 or 4
• Buffered Clock
• Asynchronous counter
• Control circuits
• Storage Registers
• Clock pulse