74ACT11374DWG4

74ACT11374DWG4 Overview

It is embeded in 24-SOIC (0.295, 7.50mm Width) case. There is an embedded version in the package Tube. The output it is configured with uses Tri-State, Non-Inverted. This trigger uses the value Positive Edge. This electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. In the operating environment, the temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. It belongs to the 74ACTseries of FPGAs. A frequency of 70MHzshould be the maximum output frequency. A total of 1elements are present in it. Currently, there are 24 terminations. The 74ACT11374 family contains it. It is powered by a voltage of 5V . This T flip flop has a capacitance of 4pF farads at the input. A device of this type belongs to the family of ACT. There is an electronic part that is mounted in the way of Surface Mount. This board has 24 pins. This device exhibits a clock edge trigger type of Positive Edge. The part is included in FF/Latches. The design is based on 8bits. Despite its superior flexibility, it relies on 8 circuits to achieve it. An electrical current of 5V volts is applied to it. There are 2 ports embedded in the flip flops. High efficiency requires the supply voltage to be maintained at 5V. With an output current of 24mA, it is possible to design the device in any way you want. There is 8μA quiescent current consumption by it.

74ACT11374DWG4 Features

Tube package
74ACT series
24 pins
8 Bits
5V power supplies

74ACT11374DWG4 Applications

There are a lot of Texas Instruments 74ACT11374DWG4 Flip Flops applications.

• Reduced system switching noise
• Count Modes
• Single Up Count-Control Line
• Memory
• Shift Registers
• 2 – Bit synchronous counter
• ATE
• Supports Live Insertion
• Computers
• Shift registers