74ACT174MTR

74ACT174MTR Overview

16-SOIC (0.154, 3.90mm Width)is the way it is packaged. It is contained within the Tape & Reel (TR)package. Non-Invertedis the output configured for it. This trigger uses the value Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at a temperature of -55°C~125°C TA. This logic flip flop is classified as type D-Type. JK flip flop is a part of the 74ACTseries of FPGAs. A frequency of 200MHzshould not be exceeded by its output. In total, there are 1 elements. This process consumes 4μA quiescents. A total of 16 terminations have been made. The 74ACT174family includes it. The D flip flop is powered by a voltage of 5V . This JK flip flop has a 4pFfarad input capacitance. A device of this type belongs to the family of ACT. There is an electronic part that is mounted in the way of Surface Mount. As you can see from the design, it has pins with 16. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This device has the base part number FF/Latches. This flip flop is designed with 6 Bits. To achieve this superior flexibility, 7 circuits are used. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. There are 5V power supplies attached to it. The supply voltage should be maintained at 5V for high efficiency. The JK flip flop is with 6 output lines to operate.

74ACT174MTR Features

Tape & Reel (TR) package
74ACT series
16 pins
6 Bits
5V power supplies

74ACT174MTR Applications

There are a lot of STMicroelectronics 74ACT174MTR Flip Flops applications.

• QML qualified product
• Dynamic threshold performance
• Clock pulse
• Single Up Count-Control Line
• Latch
• Memory
• Parallel data storage
• Power down protection
• Supports Live Insertion
• Bus hold