74ACT174PC

74ACT174PC Overview

It is packaged in the way of 16-DIP (0.300, 7.62mm). As part of the package Tube, it is embedded. There is a Non-Invertedoutput configured with it. There is a trigger configured with Positive Edge. The electronic part is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis used as the supply voltage. It is operating at -40°C~85°C TA. D-Typedescribes this flip flop. JK flip flop is a part of the 74ACTseries of FPGAs. It should not exceed 200MHzin its output frequency. A total of 1 elements are present. This process consumes 40μA quiescents. This D latch belongs to the family of 74ACT174. There is 4.5pF input capacitance for this T flip flop. There is an electronic part mounted in the way of Through Hole. It is designed with 16 pins. The clock edge trigger type for this device is Positive Edge. It is designed with a number of bits of 6. To achieve this superior flexibility, 7 circuits are used. In order to achieve high efficiency, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop. It has 3lines. -24mA is set as the high level output current. 24mAis set as the low level output current. If the operating temperature is lower than 85°C, it is recommended. Operating temperatures should be above -40°C. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. In this case, it supports a maximum supply voltage of 5.5V. The frequency can be set to 200MHz.

74ACT174PC Features

Tube package
74ACT series
16 pins
6 Bits

74ACT174PC Applications

There are a lot of ON Semiconductor 74ACT174PC Flip Flops applications.

• Divide a clock signal by 2 or 4
• Bus hold
• Functionally equivalent to the MC10/100EL29
• Common Clocks
• Power down protection
• Set-reset capability
• Data Synchronizers
• Test & Measurement
• Clock pulse
• Data storage