74ACT174SCX

74ACT174SCX Overview

The item is packaged in 16-SOIC (0.154, 3.90mm Width)cases. You can find it in the Tape & Reel (TR)package. There is a Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. Surface Mountis positioned in the way of this electronic part. A voltage of 4.5V~5.5Vis required for its operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. Its output frequency should not exceed 200MHz. In total, there are 1 elements. During its operation, it consumes 40μA quiescent energy. The 74ACT174 family contains it. This JK flip flop has a 4.5pFfarad input capacitance. There is an electronic part mounted in the way of Surface Mount. This board is designed with 16pins on it. This device has Positive Edgeas its clock edge trigger type. The design is based on 6bits. The superior flexibility of this product is achieved by using 7 circuits. The supply voltage should be maintained at 5V for high efficiency. There are 6 output lines on it. This input has 3lines. -24mAis the output current at high level. The low level output current is set to 24mA. Operating temperatures should be lower than 85°C. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. There is a maximum supply voltage of 5.5V. This frequency can be achieved 140MHz.

74ACT174SCX Features

Tape & Reel (TR) package
74ACT series
16 pins
6 Bits

74ACT174SCX Applications

There are a lot of ON Semiconductor 74ACT174SCX Flip Flops applications.

• Data Synchronizers
• Clock pulse
• ESD protection
• Power down protection
• Test & Measurement
• Circuit Design
• Dynamic threshold performance
• Asynchronous counter
• QML qualified product
• Storage registers